Reset a Yealink IP Phone to factory default settings

Reset a Yealink IP Phone to factory default settings

Method 1: Via web interface.
  1. Login in the web UI of the phone
  2. Go to Settings → Upgrade page, select Reset to Factory Settings
  3. Press OK to continue, press Cancel to quit.
Method 2: Via phone menu.
  1. Press Menu Softkey.
  2. Go to Settings → Advanced UI, enter the password to continue.
    Select Reset to Factory option.
  3. The LCD screen will prompt you with: “Warning, Reset to Factory Setting”. Press OK to continue.
Method 3: Hard reset on the device

Press and hold the “OK” button for about 10 seconds. Select Yes when a new window appears saying Reset to Factory Defaults

Note: The phone can take a few minutes to reset to factory default settings. Ensure that the device does not lose power during this time or it may cause damage to the phone’s software.


    • Related Articles

    • How to reset Polycom VoIP Phones to factory default

      The Steps Below Describe how to perform a hard reset on a Polycom Phone Using the default password Press the Home button. Go to Settings > Advanced. Enter the default admin password. The default admin password is 456. Go to Administration Settings > ...

    • How to Factory Reset Yealink W52P DECT Phones

      Objective Reset Yealink DECT Base Station to Factory Defaults using the GUI or through the physical base Applies To Yealink W52P & W52H Yealink W60P & W56H Procedureactory reset Yealink W52P (GUI) 1. Log in to the base. For a provisioned base use: ...

    • How to use the TFTP Recovery Mode on Yealink Devices

      Overview: Also known as a Recovery Mode Update, the TFTP process can be used to save what can be seen as an otherwise dead phone. This process is most useful in the scenario that a phone either gets stuck in a boot loop, or stays on a Welcome ...

    • How to Pair a Yealink W52P Handset with Base Station

      Objective Pairing a Yealink W52P handset with the base station. Applies To Yealink W52P DECT Handset Procedure When the handset LCD screen prompts “Press base paging 2s then press Reg.,” long press the Wireless button on the base station until the ...

    • Yealink T33G Models Phone User Manual

      Below is attached a document that contains a Yealink T33G model User's Guide for your convenience. If any other information is needed you can contact us by sending us a ticket to support@voicewareusa.com or calling us at our office 305-503-7782 ...