How to Factory Reset Yealink W52P DECT Phones

How to Factory Reset Yealink W52P DECT Phones

Objective

Reset Yealink DECT Base Station to Factory Defaults using the GUI or through the physical base

Applies To

  • Yealink W52P & W52H
  • Yealink W60P & W56H
  1. 1. Log in to the base.

    For a provisioned base use:
      • username:  admin
      • password:  7627
    • For a factory reset base use:
      • username:  admin
      • password:  admin
  2. Navigate to the Phone tab > Upgrade.
  3. Click Reset Now.



Factory Reset Yealink W52P (Manually)

  1. Power off the unit - if powered by PoE this might mean unplugging the network cable.
  2. Wait 15 seconds.
  3. Press and hold the connect button on the base station.
  4. Reconnect the power.
  5. Wait until all 3 status lights are on, showing solid green.
  6. Release the button and wait 5 minutes.
  7. Power off the unit.
  8. Wait 15 seconds.
  9. Reconnect the power.
  10. Your phone may update its configuration after the reboot which may result in a second reboot process automatically within a minute or two of the first reboot.

              

               Note:  You will need to re-pair the handset after resetting the base station back to factory defaults to get the base IP address   


 



    • Related Articles

    • Supported Phones Models on Voiceware Platform

      Below are the current supported devices that can be used with Voiceware Platform. Newer models will be added when they become available. Brand and Models: 1. Cisco Cisco 6841 * Cisco 6851 * Cisco 7811 * Cisco 7821 * Cisco 7841 * Cisco 7861 * Cisco ...

    • Reset a Yealink IP Phone to factory default settings

      Method 1: Via web interface. Login in the web UI of the phone Go to Settings → Upgrade page, select Reset to Factory Settings Press OK to continue, press Cancel to quit. Method 2: Via phone menu. Press Menu Softkey. Go to Settings → Advanced UI, ...

    • How to Pair a Yealink W52P Handset with Base Station

      Objective Pairing a Yealink W52P handset with the base station. Applies To Yealink W52P DECT Handset Procedure When the handset LCD screen prompts “Press base paging 2s then press Reg.,” long press the Wireless button on the base station until the ...

    • How to reset Polycom VoIP Phones to factory default

      The Steps Below Describe how to perform a hard reset on a Polycom Phone Using the default password Press the Home button. Go to Settings > Advanced. Enter the default admin password. The default admin password is 456. Go to Administration Settings > ...

    • How to use the TFTP Recovery Mode on Yealink Devices

      Overview: Also known as a Recovery Mode Update, the TFTP process can be used to save what can be seen as an otherwise dead phone. This process is most useful in the scenario that a phone either gets stuck in a boot loop, or stays on a Welcome ...